HoMedics enviraScape Manuel De Montage Et D'utilisation page 4

IB-WFLSERE-1110-01_Layout 1 22/12/2010 11:35 Page 4
ASSEMBLY AND INSTRUCTIONS FOR USE :
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch located at the
front of the pump. The speed is indicated by a plus (+) and minus (-) sign. To increase the
speed, move the switch slowly downward in the direction of the plus sign. At its highest
speed level, the switch will cease to move any further. To decrease the pump speed, move
the switch upward toward the minus sign. Similarly, at its lowest speed, the switch will cease
to move any further. NOTE: It is recommended the pump be set at its highest speed during
assembly and later adjusted to a lower setting if desired. Be sure to unplug the pump before
adjusting the speed setting.
3. Insert the tube (located on the bottom of fountain top) into the pump.
4. Fill base with tap water to 1" from top. We recommend using distilled water to prevent
mineral build up.
5. Set the fountain top onto the base by notch so it sits level.
6. Put 2 Tea-lights into the glass candle holders one by one, then light them up.
7. Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this time.
8. Set the fountain on a level, waterproof surface.
9. Plug the cord into 230V-240V household outlet. The fountain is controlled by the switch
located on the power cord. If pump doesn't operate, rotate in-line switch once to turn "on"
and once more to turn "off". Monthly maintenance will add to your pump's life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip Loop'.
This will prevent water from running down the cord into the electrical outlet.
10.Arrange the river rocks provided around the base of 2 candle holders. (If splashing occurs,
rearrange rocks until there is no more splashing).
All manuals and user guides at all-guides.com
4