Xavax 00110905 Mode D'emploi page 7

g Operating Instructions
Digital Timer
Getting started:
Take off the battery cover; remove the insulating strips and insert a
new battery (3 V/CR2032): negative pole (-) is inside, positive pole (+)
is visible.
Settings:
Time/alarm time:
– Press the "Mode" button for three seconds to set the time.
– You can switch between AM/PM and 24-hour time using the "10
SEC" button (4).
– Set the tens digit of the hour using the "10 MIN" button (2).
– Set the ones digit of the hour using the "1 MIN" button (3).
– Press the "START/PAUSE"" button (5) to set the minutes.
– Press the "START/PAUSE" button (5) to set the alarm time. A bell
symbol in the display shows the alarm time mode.
– Repeat steps 2 to 5. If you do not press another button within 3
seconds, the setting mode ends automatically.
– The alarm time that is set is activated by pressing the "START/
PAUSE" button. In clock mode, this is shown by the bell symbol (B4).
Timer:
– Press the "Mode" button (7). The display changes to 00.00.
– Set the required time using the buttons (2) (3) (4).
– Begin the countdown by pressing "Mode" (5). Press the button (5)
again if you need to pause the timer. After the time that was set
has elapsed, a rising signal tone sounds. Use the "START/PAUSE"
button to stop the tone, or reset the timer by pressing the "Clear"
button (6).
6