Electric Brake; Hex Wrench Storage - Makita 5007N Manuel D'instruction

*Always follow manufacturer instructions*
NOTE:
When changing the positive stopper's position,
•
loosening the lever and tilting the bevel angle to
less than the desired stopper position number
allows to change it.
When the arrow on the positive stopper points 22.5,
•
the bevel angle can be adjusted 0 - 22.5°;when the
arrow points 45, it can be adjusted 0 - 45°; when
the arrow points 56, it can be adjusted 0 - 56°.
Sighting
B
014096
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
Switch action
008675
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.

Electric brake

For model 5007NFA only
This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop blade after switch
trigger release, have tool serviced at a Makita service
center.
The blade brake system is not a substitute for lower
guard. NEVER USE TOOL WITHOUT A FUNCTIONING
LOWER GUARD. SERIOUS PERSONAL INJURY CAN
RESULT.
1. Base
A
1
1. Switch trigger
1
*AAA Rent-All 225-291-1356*
Lighting the lamp
(For models 5007NF,5007NFA)
008676
CAUTION:
Do not apply impact to the lamp, which may cause
•
damage or shorted service time to it.
Do not look in the light or see the source of light
•
directly.
The lamp lights up when the tool is plugged. The lamp
keeps on lighting until the tool is unplugged.
If the lamp does not light up, the mains cord may be
defective. The lamp is lit but the tool does not start even
if the tool is switched on, the carbon brushes may be
worn out, the motor or the ON/OFF switch may be
defective.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.

Hex wrench storage

1
2
008677
Hex wrench is stored on the tool. To remove hex wrench,
rotate it toward yourself and pull it out.
To install hex wrench, place it on the handle and turn it
until it comes into contact with the protrusion on the
handle.
7
1. Lamp
1
1. Hex wrench
2. Protrusion