SilverCrest SSBS 3.0 A2 Mode D'emploi page 15

Troubleshooting
The remote release 8 will not switch on.
► The battery is empty. Replace the battery (see section
Inserting/replacing the battery).
The Bluetooth
► The Bluetooth
Activate the Bluetooth
Please refer to its operating instructions for more information.
► The distance between the remote release 8 and the smart-
phone is too big. Make sure that the remote release 8 is no
more than 10 meters away from the smartphone.
► Your smartphone may be using an unsupported operating
system. Check the version of the operating system on your
smartphone (for supported operating systems, see section
Technical data).
No image is captures when the
► Each manufacturer determines the key assignment of their
camera app themselves. Therefore, various malfunctions may
occur when the
in instead of taking a picture. In this case, check the settings
of the operating system to see whether the settings offer an
option for setting the volume control (+) as an additional
trigger button.
The operating LED 0 flashes red every second.
► The battery in the remote release 8 is empty and must be
replaced (see section Inserting/replacing the battery).
Cleaning
NOTICE
► To avoid irreparable damage to the product, ensure that
no moisture gets into it during cleaning.
► Do not use caustic, abrasive or solvent-based cleaning
materials. These can damage the surfaces of the product.
♦ Clean the product with a lightly moistened cloth and a mild
detergent only.
│ GB │ IE
■ 12
connection cannot be established.
®
function on the smartphone is not activated.
®
function on your smartphone.
®
button q is pressed, e.g. camera zooms
button q is pressed.
SSBS 3.0 A2