Loading The Paper Roll - KERN and SOHN YKT-01 Mode D'emploi

3.2

Loading the paper roll

- Switch off instrument.
- Move printer cover 3 backwards (a) and take it off.
- Remove the plastic shaft and guide the new paper roll core onto it (when changing
paper: Take out plastic shaft and remove the old roll core and if necessary any paper
parts that have remained in the printer).
Manual Feed
- Open clamp (b) in the printer.
- Place the new paper roll on the table behind the printer and unwind ca. 15 cm.
Note: Unwind the paper from the underside (see picture below), the paper end must
be a straight, clean-cut.
- Switch the unit on. On the display appears in the Start menu the following command
„Load paper!"
46