Putting Into Operation; Power Supply; Mains Power Supply; Battery Power Supply - KERN and SOHN YKT-01 Mode D'emploi

3.

Putting into operation

3.1

Power supply

Connect the statistics printer with the supplied mains power adapter to a mains power source
or insert 6 standard batteries AA 1,2 V.

3.1.1 Mains power supply

- Connect the mains power adapter to the mains (observe the voltage) and with the 12 pin
connector socket.
- Only use the supplied mains power adapter.

3.1.2 Battery power supply

- Remove cover 14 observing the arrow direction on the rear side of the instrument.
At the same time this cover closes the battery compartment:
- Insert batteries, check the polarity on the underside of the instrument.
- Replace the cover.
13
45