Sony a7CR Mode D'emploi page 8

- When using the camera with
[Auto Power OFF Temp.] set to
[High]
Sony lenses/accessories
Using this unit with products from
other manufacturers may affect its
performance, leading to accidents or
malfunction.
Note on the 5 GHz band for
wireless LAN
When using the wireless LAN function
outdoors, set the band to 2.4 GHz
by following the procedure below.
(WW685965 only)
• MENU 
 [Wi-Fi Frequency Band]
How to turn off wireless network
functions (Wi-Fi, etc.) temporarily
When you board an airplane,
etc., you can turn off all wireless
network functions temporarily using
[Airplane Mode].
For Customers in the
U.S.A. and Canada
This equipment complies with FCC
radiation exposure limits set forth
for an uncontrolled environment and
meets the FCC radio frequency (RF)
Exposure Guidelines. This equipment
has very low levels of RF energy that
is deemed to comply without testing
of specific absorption rate (SAR).
The available scientific evidence does
not show that any health problems
are associated with using low power
wireless devices. There is no proof,
however, that these low power
wireless devices are absolutely safe.
Low power Wireless devices emit low
levels of radio frequency energy (RF)
in the microwave range while being
used. Whereas high levels of RF can
produce health effects (by heating
EN
tissue), exposure of low-level RF that
8
(Network)  [Wi-Fi]
does not produce heating effects
causes no known adverse health
effects. Many studies of low-level
RF exposures have not found any
biological effects. Some studies
have suggested that some biological
effects might occur, but such
findings have not been confirmed by
additional research.
This equipment has been tested and
found to comply with ISED radiation
exposure limits set forth for an
uncontrolled environment and meets
RSS-102 of the ISED radio frequency
(RF) Exposure rules.
For Customers in the
U.S.A.
For question regarding your product
or for the Sony Service Center nearest
you, call 1-800-222-SONY (7669) .
Supplier's Declaration of Conformity
Trade Name : SONY
Model : WW685965
Responsible Party : Sony Electronics
Inc.
Address : 16535 Via Esprillo, San
Diego, CA 92127 U.S.A.
Telephone Number : 858-942-2230
Important note on use of 5 GHz
wireless LAN
Compliance with FCC requirement
15.407(c)
Data transmission is always initiated
by software, which is the passed
down through the MAC, through the
digital and analog baseband, and
finally to the RF chip. Several special
packets are initiated by the MAC.
These are the only ways the digital
baseband portion will turn on the RF
transmitter, which it then turns off
at the end of the packet. Therefore,
the transmitter will be on only while
one of the aforementioned packets
is being transmitted. In other words,