Panasonic Omnivision PV-C2523-K Manuel D'utilisation page 34

All manuals and user guides at all-guides.com
Cable Box Universal Remote Control Feature
Universal Remote Control is...
The Remote Control may be set up to control some basic
DSS or Cable box functions.
The Universal Remote Control Setup
Find your DSS box or Cable box Brand Code
1
Number from one of the charts on the next
page.
Setup remote. Hold down DSS CABLE and
2
press number keys to enter code.
• For code 100 or greater, fi rst press 100 key, then the
remaining digits. e.g. for 102, press 100, then press 0, and
then press 2.
Confi rm code entry. Press POWER* to turn
3
selected unit ON or OFF.
• See below for controllable functions in each mode.
Notes
• Please repeat the Universal Remote Control Setup after
replacing remote control batteries.
• The remote control will not operate all DSS receivers or Cable
Boxes made by the manufacturers listed. If you get no results,
your particular brand cannot be controlled.
Using the Universal Remote Control
Once the remote control has been properly set up, you can
select COMBO, DSS or CABLE mode depending on which
functions you wish to control. (See below.)
Press COMBO or DSS CABLE on the remote control
to select the desired mode. (See below for buttons
available in each mode.)
Set to COMBO:
• All TV and VCR functions.
Set to DSS CABLE:
• Basic VCR functions, e.g. PLAY, REC, etc.
• CABLE/DSS functions, e.g. POWER, ENTER, number keys
(except 100 key), CH UP/DOWN.
34 34
POWER
COMBO
DSS/CABLE
NUMBER Keys
ENTER