INTRATONE 02-0301 Montage page 13

EN : What is the failure ?
Message on display: "Communication fault"
Keys and or LCD screen not backlit
Backlit keys while the display is not (or vice versa) Contact our technical services
When passing a badge, the LED of the reader
turns green, but the door does not open.
The interphone says "Call in progress" but the
resident does not hear the visitor
The platinum says "Call impossible" without call
tone
The resident does not see the visitor in his phone
Warranty operating guarantees:
The Vendone video intercom is guaranteed within a temperature range of -20°C and +60°C and at a relative humidity level not
exceeding 70%.
It must be installed according to the Top/Bottom directions given in these instructions and on the device.
The installation must be carried out by qualified personnel with the necessary knowledge for a safe assembly of the equipment.
Do not install outdoors in extreme temperatures (Finland, Sweden, Norway).
This kit includes the necessary elements to ensure a safe installation of the equipment.
End-of-life recycling of the product:
The Vendone video intercom and its accessories must not be discarded with unsorted municipal waste, but must be
disposed of via the WEEE (Waste Electrical and Electronic Equipment) collection and recycling system.
Simplified declaration of conformity
The undersigned, COGELEC, declares that access control type radio equipment for collective housing is in compliance
with Radio Equipment Regulations 2017 (SI 2017/1206). The full text of the declaration of conformity is available at
the following internet address:
Simplified declaration of conformity
The undersigned, COGELEC, declares that access control type radio equipment for collective housing is in
compliance with Directive 2014/53/EU (RED).The full text of the EU declaration of conformity is available at the
following internet address:
Technical specifications :
Operating voltage
Radio frequency characteristics
Storage Temperatures range
Operating Temperatures range
Operating environment
V233-5089-AA 13/16
Help
- Check the wiring between the block, the board and the
central unit: D + / D-
- The display must indicate the greeting.
- Bad wiring on + and or - terminal blocks
- Relay of the central does not work.
- Check wiring between the control panel and the door
Review A + / A- wiring
Check wiring to the block and leds level
Phone network not available
-Check wiring V + / V-
http://certificates.intratone.com/
http://certificates.intratone.com/
12 – 24Vdc max. (ES1)
< 100W (PS2)
100 Hz - 9 kHz
119 kHz - 135 kHz
13.553 MHz - 13.567 MHz
433.05 MHz – 434.79 MHz
-20 to +60°C
-20 to +60°C
IP54
How to solve the problem!
< 120 dBμA/m @10m
< 66 dBμA/m @10m
< 60 dBμA/m @10m
Receiver category = 2