Publicité
Les langues disponibles
Les langues disponibles
access point cannot be used for this service. The
packet data internet access point is asked when GPS
is used for the first time in your device.
To enable or disable different positioning methods,
such as Bluetooth GPS, press
Settings
General
>
Positioning
methods.
GPS receiver
The GPS receiver is located in the bottom of the
device. When using the receiver, slide the numeric
keypad open, and from an upright position, move
the device to an angle of about 45 degrees, with an
unobstructed view of the sky. Do not cover the
numeric keypad with your hand.
Establishing a GPS
connection may take
from a couple of
seconds to several
minutes. Establishing
a GPS connection in
the car may take
longer.
The GPS receiver
draws its power from the device battery. Using the
GPS receiver may drain the battery faster.
86
All manuals and user guides at all-guides.com
, and select
Tools
Positioning
>
>
About satellite signals
If your device cannot find the satellite signal,
consider the following:
If you are indoors, go outdoors to receive a better
●
>
signal.
If the numeric keypad slide is closed, open it.
●
If you are outdoors, move to a more open space.
●
Ensure that
●
your hand does
not cover the
GPS antenna of
your device.
See "GPS
receiver"
, p. 86.
If the weather
●
conditions are bad, the signal strength may be
affected.
If the power saver turns on while the device is
●
attempting to establish a GPS connection, the
attempt is interrupted.
Establishing a GPS connection may take from a
●
couple of seconds to several minutes.
Satellite status
To check how many satellites your device has found,
and whether your device is receiving satellite
Publicité
