Nokia N95 Guide D'utilisation page 143

is set to Beep once or Silent, automatic answer
is disabled.
Lights — Set whether lights remain on or are
●
switched off after the time-out. This setting is not
available for all enhancements.
TV-out settings
To change the settings for a TV-out connection,
select TV-Out and from the following:
Default profile — Set the profile that you want
●
activated each time you connect a Nokia Video
Connectivity Cable to your device.
TV screen size — Select the aspect ratio of the
●
TV: Normal or Widescreen
TV system — Select the analogue video signal
●
system that is compatible with your TV.
Flicker filter — To improve image quality on the
●
screen of your TV, select On. The flicker filter may
not diminish image flicker on all TV screens.
Security settings
Phone and SIM
Press , and select Tools
General Security
> >
PIN code request — When active, the code is
●
requested each time the device is switched on.
Deactivating the PIN code request may not be
allowed by some SIM cards.
All manuals and user guides at all-guides.com
for widescreen TVs.
Settings
> >
Phone and SIM card.
PIN code, PIN2 code, and
●
change the lock code, PIN code, and PIN2 code.
These codes can only include the numbers from
0 to 9.
If you forget the PIN or the PIN2 code, contact
your service provider. If you forget the lock code,
contact a Nokia Care point or your service
provider.See "Access codes", p. 16.
Avoid using access codes similar to the
emergency numbers to prevent accidental
dialling of the emergency number.
Keypad autolock period
●
keypad is locked when your device has been idle
for a certain period of time.
Phone autolock period
●
unauthorised use, you can set a time-out after
which the device automatically locks. A locked
device cannot be used until the correct lock code
is entered. To turn off the autolock period, select
None.
Tip: To lock the device manually, press the
power key. A list of commands opens.
Select Lock phone.
Lock keys if slide closed
●
keypad is locked when you close the 2-way slide.
Tip: To lock or unlock the keypad manually
when the slide is closed, press the left
selection key, then the right selection key.
Lock code — You can
— Select whether the
— To avoid
— Select whether the
143