Toshiba Carrier MMY-MAP0726FT6P-UL Manuel Du Propriétaire page 12

▼ Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
(2)
(3)
(1)
(4)
(2)
(4)
(1)
(3)
(1)
(2)
(4)
(3)
(2)
(1)
(3)
(4)
◆ Setting the louver lock
1
Push and hold the button (right side
of the button) for at least 4 seconds while
running is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the button (left side of the
button) to select a unit.
The unit number changes each time the button is
pushed.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
Unit No.
1-4
The fan of the selected unit runs, and the louver
swings.
21-EN
Carrier 1122002001 EN FR.indb 11 Carrier 1122002001 EN FR.indb 11
3
Push the "TEMP. " buttons to
display the number of the louver to fix its
direction.
The selected louver swings.
4
Push the buttons to select the
direction of the louver you do not want to
swing.
(1) (2) (3)
0001 0002 0003
(4) (5)
0004 0005
* If (4) or (5) is selected, condensation may occur
during cooling.
Electrical control box
03
Refrigerant
pipe
04 02
Drain pipe
01
5
Push the button to confirm the setting.
When the setting is confirmed, the mark lights
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same
unit, repeat from Step 3.)
– 11 –
6
Push the button to finish the setting.
0001 - 0005
(Louver position
Louver No.
code)
* F1 appears in the CODE No. section on the
remote control. This indicates that the louver 01
shown in the following figure is selected.
NOTE
Even in louver lock mode, the louver temporarily
moves in the following cases:
• When the air conditioner is stopped
• When heating starts
• When defrosting
• When thermostat
◆ Releasing the louver lock
Set "0000" in Step 4 of "Setting the louver lock".
The mark disappears.
* Steps 1 - 3 and 5, 6 of "Setting
the louver lock" also apply to
SET DATA
releasing the lock.
◆ Adjusting the horizontal direction
1
Push and hold the and "TEMP.
buttons for at least 4 seconds while
running is stopped.
blinks.
"01" appears in CODE No.
2
Push the button (left side of the
button) to select a unit
The unit number changes each time the button is
pushed.
Unit No.
Unit No. Unit No.
1-1 1-2 1-3
No display Unit No.
1-4
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP. " buttons to
change the CODE No. to "45".
4
Push the "TIME " buttons to select a
direction.
Direction SET
Direction setting
DATA
Smudging reduction position
"0000"
(reduces ceiling smudging)
Cold draft preventive position
0000 "0002" (Prevent cold draft)
[Factory default]
5
Push the button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
"
22-EN
6/22/16 2:10 PM 6/22/16 2:10 PM