Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
CAUTION: The camera's base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed.
2. Route the ethernet and power cable to the connecting place.
3.
ing screws.
4. Set the camera's viewing angle by using the driver. (Refer to 'Pan & Tilt
adjustments').
5. Put the sunshield to the camera unit and tighten the sunshield-bolts.
Mounting Screw: 3,5x25 mm
Plastic Anchor: 6x30 mm
EN
-
7
Publicité
