Publicité
Les langues disponibles
Les langues disponibles
WASHER CARE (cont.)
2. Chlorine Bleach Procedure:
a. Open the washer door and remove any clothing
or items.
b. Open the dispenser drawer and add liquid
chlorine bleach to the "Max" level in both the bleach
compartment and the fabric softener compartment.
Either traditional or HE chlorine bleach can be used.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause washer damage
over time.
c. Close the washer door and the dispenser drawer.
d. Do not add any detergent or other chemicals to the
washer when following this procedure.
e. Close the washer door.
f. Select the Clean Washer with affresh
g. On some models: Select the FanFresh
help dry the washer interior after the cycle is complete.
NOTE: The washer remembers your last option
selection and will use it for future wash cycles until you
deselect that option. While the fan is on, the washer
door will lock. To unlock the door, touch the Power
button.
h. Touch and hold the Start button to begin the cycle.
The Clean Washer with affresh
described below.
NOTE: For best results, do not interrupt cycle.
Description of Clean Washer with affresh
Operation:
1. The Clean Washer with affresh
whether clothing or other items are in the washer.
2. If no items are detected in the washer, it will proceed
with the cycle.
a. If any items are detected in the washer, "rL"
(remove load) will be displayed. The door will unlock.
Open washer and remove any garments from the
washer drum.
b. Touch the Power button to clear the "rL" code.
c. Touch and hold the Start button to restart the cycle.
3. Steam models only: During the first 20 minutes of the
cycle, it will activate the steamer but the drum will not spin
or fill with water. You may see condensation on the door
glass during this initial phase. If you are using an affresh
Washer Cleaner tablet, it will not dissolve completely
during the steam phase. This is normal.
After the cycle is complete, leave the door open slightly to
allow for better ventilation and drying of the washer interior.
Cleaning the Dispensers
After a period of using your washer, you may find some
residue buildup in the washer's dispensers. To remove
residue from the dispensers, remove the drawer and wipe
the surfaces with an affresh
damp cloth and towel dry either before or after you run the
Clean Washer with affresh
®
cleaner, if needed.
IMPORTANT: Dispenser is not dishwasher safe.
Cleaning the Outside of the Washer
Use an affresh
Machine Cleaning Wipe or a soft, damp
®
cloth or sponge to wipe up any spills. Occasionally wipe
the outside of your washer to help keep it looking new. Use
an affresh
Machine Cleaning Wipe or mild soap and water.
®
IMPORTANT: To avoid damaging the washer's finish,
do not use abrasive products.
20
All manuals and user guides at all-guidesbox.com
cycle.
®
®
option to
Cycle Operation is
®
Cycle
®
cycle will determine
®
Machine Cleaning Wipe or a
®
cycle. Use an all-purpose surface
CLEAN WASHER CYCLE REMINDER
NOTE: Not all models have the Clean Washer with affresh
cycle reminder light.
The Clean Washer with affresh
will flash at the end of a wash cycle
when the washer has run 30 wash
cycles. This is a reminder to run the
Clean Washer with affresh
If the Clean Washer with affresh
LED will stop flashing at the end of a wash cycle after running
3 more regular wash cycles. After 30 more wash cycles are
completed, the Clean Washer with affresh
flash at the end of a wash cycle as a reminder.
REMOVING THE DISPENSER
Load & Go™ Dispenser Drawer
To remove:
1. Pull dispenser drawer out until it stops.
2. Press down on the release tab and pull straight out to
remove the dispenser.
3. Lift off cover panel by
pulling straight up.
®
To replace:
1. Slide cover panel back
onto posts on dispenser.
2. Align edges of dispenser
with guides in washer;
then slide dispenser
back into slot.
LED
®
cycle.
®
cycle is not turned on, the
®
LED will again
®
®
Publicité
