Publicité
Les langues disponibles
Les langues disponibles
The tilt can be adjusted between 0° and 45° with two
distinct directions.
1. Unplug the power cord (10);
2. Loosen the fixing screws and remove the cover of the
base plate (13);
3. Remove the dust extraction port (11);
4. Loosen the fixing screw of the base plate;
5. Adjust the base plate gear on the saw blade gear
according to the desired tilt. Check the angle on the
cutting angle scale (12);
0° - Vertical cut;
45° - Bevel cut (left and right);
6. Screw the base plate fixing screw and assemble the
remaining parts in the reverse order of disassembly.
The parallel guide (2) is used to perform a parallel cut to
the end (edge) of the workpiece.
1. Loosen the parallel guide fixing screws (2);
2. Set the guide according to the desired cutting width. The
cutting width value is shown by the base plate notch (13),
in the scale of the parallel guide rail (2);
3. Tighten the fixing screws.
1. Place the base plate (13) over the workpiece;
2. Press the ON/OFF switch lock-on button (8) and the
ON/OFF switch simultaneously (7);
If you do not press the lock-on button, the ON/OFF switch
remains locked;
4. Let the saw blade reach its maximum speed. After that,
direct the blade towards the point you want to start
cutting;
5. Apply a slight pressure over the jigsaw towards the
workpiece to avoid vibrations or the possibility of
breaking the blade;
6. Guide slowly the jigsaw so the saw blade can move along
the cutting line drawn on the workpiece the cut is
finished;
7. To turn the jigsaw off, release the "ON/OFF" switch.
.
The rotation speed can be adjusted using the "ON/OFF"
switch (7). The blade speed increases as the "ON/OFF"
switch is pressed. When the switch is completely pressed,
the blade reaches its maximum speed.
The adjustment of the pendulum stroke of the blade is
controlled in the pendulum stroke selector (5) with 3
different positions (0, 1, 2 and 3).
▪ Position 0 – no pendulum movement:
- Cuts in hard materials (ceramics or steel) and thin
pieces (steel plate);
- Cuts in sharp edges.
▪ Position 1 – slight pendulum movement:
- Cuts in medium hard materials (for ex. hard wood or
plastic).
▪ Positions 2/3 - medium/intense pendulum movement:
- Soft materials (wood and plastic);
- Cuts in the direction of the fibers.
The best combination between the blade speed and the
pendulum movement depends on the material to be
worked. To determinate the ideal adjustment makes a test
cut on a piece of waste.
Publicité
