Télécharger Imprimer la page

Kohler DK2 Power OPG777 Manuel De L'utilisateur page 21

Publicité

Les langues disponibles

Les langues disponibles

STARTING INSTRUCTIONS
NOTE: Refer to the Engine Owner's Manual for complete information on starting, maintenance
and troubleshooting.
1. Move the fuel valve lever to the ON position.
2. To start a cold engine, move the choke lever to the CLOSE position. To restart a warm
engine, leave the choke lever in the OPEN position.
3. Move the throttle lever away from the SLOW position, about 1/3 of the way toward the
FAST position.
4. Turn the engine switch to the ON position.
5. Pull the starter grip until you feel resistance, then pull briskly. Return the starter grip
gently.
6. If the choke lever has been moved to the CLOSE position to start the engine, gradually
move it to the OPEN position as the engine warms up.
7. To stop the engine in an emergency, simply turn the engine switch to the OFF position.
Under normal conditions, move the throttle lever to the SLOW position and then turn
the engine switch to the OFF position. Then turn the fuel valve lever to the OFF position.
NOTE: For further information on starting and stopping the engine, refer to your Engine Owner's
Manual.

CAUTION! Turn Fuel Shut Off Valve to the "OFF" position before towing to avoid
flooding the engine.
NOTE: The engine's maximum speed is factory preset at 3,600 RPM as the no-load speed. The
throttle should be set at the maximum speed for stump grinding to reach the horsepower required
for the stump.

WARNING! Review the safety information related to operation of the stump grinder in
SECTION I: SAFETY in this manual. Make sure that you have the recommended personal
protective equipment described.
PERFORMANCE OPERATION
Approach the stump from the top, cutting straight down into the stump with the 3.5-inch wide
cutting teeth. Raise up and out of the cut, adjust to a new cutting position and repeat this process
across the entire stump.
NOTE: Move side to side to face off the stump and adjust your bow handle for comfort while
operating.

CAUTION! Tighten all bolts and teeth before each use. Teeth are not covered under
warranty.
v.220914 | 21

Publicité

loading