Publicité
Les langues disponibles
Les langues disponibles
OPERATIONAL SAFETY OVERVIEW
DANGER! Clear area of all people and property that could be
damaged. Think safely. Chips are flying projectiles and can cause
serious injury. Wear safety glasses, hearing protection, and gloves as
advised in SECTION I: SAFETY. Do not wear loose fitting clothes that
could get stuck in the machine.
DANGER! Read and understand the complete User Manual before
assembling or using this product! Failure to comprehend and
comply with warnings, cautions, and instructions for assembly and
operation could result in serious injury or death.
DANGER! Do not permit children to operate this equipment at any time.
DANGER! Do not permit others that have not read and understood the complete User
Manual to operate this equipment. Operation of power equipment can be dangerous. It is
the sole responsibility of the operator to understand the assembly and safe operation of
this product.
CAUTION! This unit is designed with a dual belt drive; there is no clutch to slip or burn up,
but your belts will need to be tightened and checked on a regular basis to maintain 100%
cutting power.
CAUTION! Store this manual in a safe place for future reference.
WARNING! NOTE: For operation in wooded areas, obtain a spark arrestor for the exhaust
system. See the engine operating and maintenance manual and check with your authorized
service center.
WARNING! TOWING: This stump grinder is equipped with pneumatic tires, a 2" in diameter
ball required (Class III recommended) and safety chains. Before towing, the safety chains
must be secured to the hitch or bumper of the vehicle. Local regulations should be checked
regarding licensing, lights, towing, etc. Turn fuel shut off valve on the engine to the "OFF"
position prior to towing. Failure to do so may result in flooding the engine. Do not exceed
15mph (24km/h) when towing this stump grinder.
MAINTENANCE
1. Consult the operating and maintenance instructions of the engine manufacturer for engine
care and maintenance.
2. All replacement parts must meet manufacturer's specifications.
TIP: Tip the stump grinder up with the cutters off the ground when pull starting.
20 | OPG777(D) man.
Publicité
