Daga N Mode D'emploi page 12

All manuals and user guides at all-guides.com
ENGLISH
All you need to do to leave this Autostop mode is to press any button
on the control keypad. The regulator then returns to the default mode
established (free mode, temperature level 1).
INSTRUCTIONS FOR USE
1) Connect the pad to the appropriate mains.
2) Turn on the product by taking the regulator control and acti-
vating the sliding on/off side switch, setting it to the "I" setting.
The electronic control immediately starts a swift check to detect any
possible problems indicted on the through a LED scan through which
the following are configured in the working mode by default: LED 1
lit up (minimum temperature level) and free mode (no time selected)
3) Set the desired temperature level, from the 4 levels available by
repeatedly pressing the temperature selection key
operates normally in free mode: Only the blue indicator LED (E) for
the selected temperature is the only thing that remains lit up on the
control screen, with everything else turned off.
However, the pad will automatically reduce its temperature after
about 90 min of continuous operation if this recommendation is not
observed, as a safety measure.
We wish to remind you that high temperatures are not required to
avail of the beneficial effects of the heat provided by the pad and that
applying excessive continued heat to the skin may lead to burns. The
highest regulator temperature settings must only be used for the time
required to attain a comfortable temperature, through which, it is
recommended to gradually reduce the temperature to a lower setting.
As indicated above, if you notice the temperature reducing after ex-
tended us of the pad at temperature levels 3 and 4, this is not indic-
ative of any fault; rather that the automatic high temperature time
control system has been activated, that is included in the Daga pads,
to prevent any excessive application of heat to the ski.
Always allow the pad to cool down prior to storage and never store
with other objects placed on top of the pad.
PROBLEM TROUBLE SHOOTER
PROBLEM
The control screen
does not light up
when the on/off side
switch is activated.
12
SOLUTION
Check that there is voltage in the out-
let used, and that the pad is correctly
plugged into it.
Ensure that the on/off side switch is in the
"I" setting.
. The pad now