EUROMAC FLOW SP250 Manuel D'instructions page 9

BEFORE USING YOUR PUMP...
Read this entire instruction leaflet carefully. It contains important information in relation to the
use of your pump and precautionary measures that may need to be taken. Reading these
instructions thoroughly will ensure you get the very best performance from the product and
ensure maximum safety.
SAFETY RECOMMENDATIONS
 For safety reasons, your submersible pump must always be connected to an earthed socket
that has been installed according to national regulations, forms part of an electricity network
that is equipped with a fuse of at least 16 Amp and has an earth leakage circuit breaker
(nominal voltage ≤30 mA).
 Check your pump, electrical cable, plug and socket before each use. Do not use if the
device is damaged and have this damage repaired by an accredited electrician. The cable is
an H07RN-F type.
 Ensure that electrical connections stay dry at all times.
 Do not touch the plug with wet hands.
 Before use, ensure that the socket to which you are connecting the pump is suitable for the
pump itself (see type plate).
 Protect the electrical cable and plug from heat, oil and sharp corners.
 Clean the drainage pipe before use.
 Before use, check to ensure that elevation or suction heights do not exceed your pump's
capacity.
 Do not use the electrical cable to hang up, lower or move the pump. Attach a rope to the
handle in order to do this. Never pull on the cable to remove the plug from the socket but
remove by pulling on the plug!
 Rinse the pump with clean water if you have used it to pump water that contains chlorine, for
example, or deposits. Bear in mind that sand and all other abrasive and corrosive
substances will increase wear and tear and impact upon the effectiveness of the pump.
 Ensure the pump is not used if it cannot drain off the water due to issues such as blocked
drainage, elevation too high, etc. This will damage the pump!
 Do not use the pump if there are persons present in the object to be pumped out. It is
forbidden to use this pump in a swimming pool.
 Sand (and similar materials) in the liquid that is to be pumped will have a corrosive effect
and will lead to increased wear and tear.
 Allowing the pump to run dry will increase wear and tear and cause overheating. Always
prevent the pump from running if no water is being moved and switch it off immediately if this
is the case.
 Close supervision is necessary when the product is used near children or incapacitated
persons. The device is not suitable for use by persons (including children) with a physical,
sensual or mental limitation or a lack of experience and knowledge, irrespective of whether
they are being supervised or have been issued with instructions in relation to the use of the
device by a person who is responsible for their safety. Always ensure that children cannot
play with the device.
 Never repair the pump, cable and/or plug yourself; always have this maintenance carried out
by an authorised expert. The importer and manufacturer accept no liability for repairs and/or
modifications to the pump if they have been carried out by someone who is not qualified to
do so. Such interventions also nullify the guarantee.
9
EN