Avigilon 1.0-H3-DC1 Guide D'utilisation page 16

5. In the Avigilon Camera Installation Tool, adjust the
camera's Image and Display settings to achieve the
desired zoom position.
Removing the Dome Cover
Remove the dome cover by loosening the 2 tamper-proof screws that
fix the cover to the base. The tamper resistant key included with the
dome camera can be used to loosen the screws.
NOTE: Be careful not to scratch the dome bubble.
Focusing the Dome Camera
NOTE: Ensure this procedure is performed after the dome cover is
installed, so the focus shift caused by the dome bubble's
refraction can be accomodated.
• In the Avigilon Camera Installation Tool, use the camera's
Image and Display settings to focus the camera lens.
a.
b.
Caution — Do not attempt to adjust the focus and zoom on
the camera manually or the camera lens may become
damaged.
For More Information
Additional information about setting up and using the device is
available in the following guides:
• Avigilon Camera Installation Tool User Guide
• Avigilon Control Center Client User Guide
• Avigilon High Definition H.264 IP Camera User Guide
The manuals are available on the Avigilon website:
support/manuals/.
8
Click the Auto Focus button to focus the lens.
If the desired focus was not achieved, use the focus
near and far buttons to adjust the focus.
http://avigilon.com/