Publicité
PLAZA S7x STEP-BY-STEP INSTALLATION
1. Loosen bracket with allan key provided, do not remove screws.
3. Fix bracket to mounting surface, single fix in centre of bracket.
Secondary fixing available if necessary.
5. Remove back plate using allen keys.
7. For loop in loop out remove gland bung to access second gland
diametre. Remove link wire when wiring in series, do not remove
end of run.
Check all cable entry points and tighten to the recommended torque rating of
6.25N/m
3
Plaza S7x Instructions: Helpline +44 (0) 845 862 6400.
All manuals and user guides at all-guides.com
2. Remove the bracket from housing using key hole slots.
4. Refit bracket and tighten screws using allan key.
6. Wiring: Single feed - Bring the wires through the gland
and connect to terminal. a) Size of cable 0.5mmcross section 3-6mm
outer.
Check all cable entry points and tighten to the recommended torque rating of 6.25N/m
8. Refit back cover, torque rating 1 newton meter.
IN
OUT
+ -
+ -
IN
OUT
+ -
INS310 Rev.1
Publicité
