Télécharger Imprimer la page

acdc PLAZA S7 Serie Instructions D'installation

Publicité

Liens rapides

PLAZA S7x INSTALLATION INSTRUCTIONS
IP67
SUITABLE FOR WET LOCATIONS
WARNING NOTICE
ENGLISH
• Only to be installed by a qualified electrician.
• Disconnect the unit from mains power before installing or servicing
to avoid shock.
• Installation must be carried out in accordance with national and local
standards.
• Class 1 luminaires must be earthed.
• Class 3 luminaires must only be used with Class 2 power supply (US
markets only).
• Use correct polarity when wiring. If in any doubt contact the
installation helpline.
• acdc luminaires are designed for lighting applications and must not
be used for any other purpose.
• Do not exceed the product specified power ratings.
• Unauthorised repairs or modifications will void warranty.
FRANCAIS
• Ne doit être installé que par un électricien qualifié.
• Débranchez l'appareil de son alimentation secteur avant d'installer ou
d'entretenir.
• L'installation doit être effectuée conformément aux normes
nationales et locales.
• Les luminaires de classe 1 doivent être mis à la terre.
• Les luminaires de classe 3 ne doivent être utilisés qu'avec une
alimentation de classe 2.
(Marchés américains uniquement).
• Utilisez la polarité correcte lors du câblage. En cas de doute,
contactez la ligne d'assistance de l'installation.
• les luminaires acdc sont conçus pour des applications d'éclairage et
ne doivent pas être utilisés à d'autres fins.
• Ne dépassez pas les valeurs de puissance spécifiées par le produit.
• Les réparations ou modifications non autorisées annulent la garantie.
1
Plaza S7x Instructions: Helpline +44 (0) 845 862 6400.
All manuals and user guides at all-guides.com
DEUTSCHE
• Nur von einem Elektrofachmann installiert werden.
• Trennen Sie das Gerät vom Netz, bevor Sie die War tung des Servers
durchführen, um Stöße zu vermeiden.
• Die Installation muss gemäß den nationalen und lokalen Normen
durchgeführt werden.
• Leuchten der Klasse 1 müssen geerdet sein.
• Leuchten der Klasse 3 dürfen nur mit Netzteil der Klasse 2
verwendet werden. (Nur US-Märkte).
• Bei der Verdrahtung die richtige Polarität verwenden. Bei Zweifeln
wenden Sie sich bitte an die Installations-Helpline.
• acdc-Leuchten sind für Beleuchtungsanwendungen ausgelegt und
dürfen nicht für andere Zwecke verwendet werden.
• Überschreiten Sie nicht die angegebenen Produktleistungen.
• Unbefugte Reparaturen oder Änderungen erlischt.
ITALIANO
• Solo per essere installato da un elettricista qualificato.
• staccare l'apparecchio dalla corrente prima installingor
manutenzione per evitare urti.
• L'installazione deve essere effettuata in conformità con le norme
nazionali e locali.
• Classe 1 apparecchi devono essere messi a terra.
• Classe 3 apparecchi devono essere utilizzati solo con classe 2 di
alimentazione (Mercati USA solo).
• Utilizzare la corretta polarità durante il cablaggio. In caso di dubbio
contattare il servizio di assistenza di installazione.
• Gli apparecchi ACDC sono progettate per applicazioni di
illuminazione e non devono essere utilizzati per altri scopi.
• Non superare il prodotto specificato potenze.
• riparazioni o modifiche non autorizzate saranno invalidare la
garanzia.
REQUIRED TOOLS
allen key sizes for bracket and
back plate are 2.5mm A/F
INS310 Rev.1

Publicité

loading

Sommaire des Matières pour acdc PLAZA S7 Serie

  • Page 1 • Bei der Verdrahtung die richtige Polarität verwenden. Bei Zweifeln installation helpline. wenden Sie sich bitte an die Installations-Helpline. • acdc luminaires are designed for lighting applications and must not • acdc-Leuchten sind für Beleuchtungsanwendungen ausgelegt und be used for any other purpose.
  • Page 2 All manuals and user guides at all-guides.com PLAZA S7x GUIDELINES AND INSTALLATION Product specific warnings. PRODUCT SPECIFIC WARNINGS ENGLISH DEUTSCHE • This product is not to be installed under water. • Dieses Produkt darf nicht unter Wasser installiert werden. • The fitting should not be exposed to harsh chemicals. •...
  • Page 3 All manuals and user guides at all-guides.com PLAZA S7x STEP-BY-STEP INSTALLATION 1. Loosen bracket with allan key provided, do not remove screws. 2. Remove the bracket from housing using key hole slots. 3. Fix bracket to mounting surface, single fix in centre of bracket. 4.
  • Page 4 M6 FLANGED NUT. 11. TREE STRAP INSTALATION: Remove strap and wrap around Torque between 5 - 10 N/m. the tree max diameter of tree 150 mm, can change strap if needed (acdc does not supply larger strap). 10mm Ø7mm 17.5mm...