Qilive Q.3622 Guide De Démarrage Rapide page 8

All manuals and user guides at all-guides.com
3.4 CALIBRATION
EN
>WARNING: THE NOZZLE AND THE PLATFORM WILL BE DAMAGED IF THE NOZZLE TIP IS
LOWER THAN THE TEST SHEET
>WARNING: THE PRINT QUALITY WILL NOT BE GOOD IF THE NOZZLE TIP IS HIGHER
THAN THE TEST SHEET
3.5 UNBLOCKING AND HOW TO LOAD THE FILAMENT
1. Select "Prepare" > "Change Filament" > "Unload Filament"
Wait until the nozzle has cooled to room temperature. Press the arm of the printing head down,
then push the filament inside the head a little until a small amount of melted filament comes out.
2. Select "Prepare" > "Change Filament" > "Unload Filament"
Then wait until the nozzle reaches the required temperature. Push the printer head arm down and
pull the filament out of the printer head. You will need an Allen key to clean the nozzle. Load the
new filament and run a "Filament Test". If everything is OK, verify the calibration of the platform
and start printing. If not, try again or contact our product support department.
4. CONTENTS OF THE SD CARD
- Complete multilingual manual
- The Qilive Repetier Host program
- The printer driver
- Some examples of object files that can be printed directly from the SD card
You will find all this information, plus a forum, FAQs, examples and programs on the website
www.qilive.com
You will also find 3D design programs and lots of additional information on the following sites:
- www.qilive.com
- www.thingverse.com
- www.sourceforge.net
- www.shapesmith.org
- www.penscad.org
IF YOU CANNOT FIND AN ANSWER TO YOUR QUESTION ON THE QILIVE WEBSITE
OR IN THE INSTRUCTIONS, PLEASE CONTACT YOUR DISTRIBUTOR:
3D-SUPPORT-Q3622@auchan.com
8