Publicité
Additional regulatory information
a) This equipment complies with Part 68 of the FCC rules
and the requirements adopted by the ACTA. On the bot-
tom of this equipment is a label that contains, among
other information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be pro-
vided to the telephone company.
b) An applicable certification jacks Universal Service Order
Codes (USOC) for the equipment is provided (i.e., RJ11C) in
the packaging with each piece of approved terminal equip-
ment.
c) A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply with
the applicable FCC Part 68 rules and requirements adopted
by the ACTA. A compliant telephone cord and modular plug
is provided with this product. It is designed to be connected
to a compatible modular jack that is also compliant. See in-
stallation instructions for details.
d) The REN is used to determine the number of devices that
may be connected to a telephone line. Excessive RENs on
a telephone line may result in the devices not ringing in
response to an incoming call. In most but not all areas, the
sum of RENs should not exceed five (5.0). To be certain of
the number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone
company. [For products approved after July 23, 2001, the
REN for this product is part of the product identifier that has
the format US:AAAEQ##TXXXX. The digits represented by
## are the REN without a decimal point (e.g., 03 is a REN of
0.3). For earlier products, the REN is separately shown on the
label.]
e) If this alarm clock equipment causes harm to the telephone
network, the telephone company will notify you in advance
that temporary discontinuance of service may be required.
But if advance notice isn't practical, the telephone company
will notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you
believe it is necessary.
All manuals and user guides at all-guides.com
f ) The telephone company may make changes in its facilities,
equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to
make necessary modifications to maintain uninterrupted
service.
g) Should you experience trouble with this equipment, please
contact your retailer for information about warranty and
service. If the equipment is causing harm to the telephone
network, the telephone company may request that you dis-
connect the equipment until the problem is resolved.
h) Please follow instructions for repairing if any (e.g. battery
replacement section); otherwise do not alternate or repair
any parts of device except specified.
i) Connection to party line service is subject to state tariffs.
Contact the state public utility commission, public service
commission or corporation commission for information.
j) NOTICE: If your home has specially wired alarm equip-
ment connected to the telephone line, ensure the instal-
lation of this alarm clock does not disable your alarm
equipment. If you have questions about what will disable
alarm equipment, consult your telephone company or a
qualified installer.
NOTICE: According to telephone company reports, AC electri-
cal surges, typically resulting from lightning strikes, are very
destructive to telephone equipment connected to AC power
sources. To minimize damage from these types of surges, a
surge arrestor is recommended.
Applicable for Coin or Pay Phone Only
To comply with state tariffs, the telephone company must be
given notification prior to connection for customer-owned coin
or credit card phone. In some states, the state public utility
commission, public service commission or corporation com-
mission must give prior approval of connection.
For use in all EU countries
Hereby, Bellman & Symfon declares that this
Alarm Clock is in compliance with the essential
requirements and other relevant provisions of
directives: RED Directive 2014/53/EU
FCC compliance statement
REN: 0.1B
US: 1PNRG01BBERXTE1
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause un-
desired operation.
Warning: Changes or modifications to this unit not expressly ap-
proved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the in-
structions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on acircuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
For a complete Declaration of Conformity please contact:
info@bellman.com or call +46 31 68 28 20
Use and disposal of batteries
Replace only with the same or equivalent type
recommended by the manufacturer. Please
dispose of old, defective batteries in an environ-
mentally friendly manner in accordance with the relevant leg-
islation in your country.
Statement for Industry Canada
Le fonctionnement de cet équipement est soumis aux conditions
suivantes:
(1) l'équipement concerné ne doit pas causer d'interférences, et
(2) il doit accepter toute interférence reçue, y compris les inter-
férences risquant d'engendrer un fonctionnement indésirable.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
This Class B digital apparatus complies with Canadian ICES-003.
Zusätzliche Information
Zweckbestimmung des Produktes: Uhr mit Wecker Funktion inkl. Vib-
rationskissen. Zulässige Betriebsbedingungen: Das Produkt darf nur
Innen verwendet werden. Reinigungshinweise: Nur mit trockenem
oder leicht feuchtem Tuch abwischen. Wartungshinweise: Akkus
können durch autorisiertes Fachpersonal ausgetauscht werden.
Bei Defekt des Blitzlichtes muss das Gerät eingeschickt werden.
Technische Daten: Betrieb mit 7.5V Netzteil inkl. 4 x AAA NiMH-
Akku (BE1350 Akkus optional) als Überbrückung bei Stromausfall.
Eingänge: Externer Trigger und Telefon (Nicht BE1350). Ausgänge:
Vibrationskissen. Hinweise zum Wiedereinsatz: Das Produkt ist nicht
für den Wiedereinsatz für eine andere Person vorgesehen.
BE1580: HMV 16.99.09.3021
BE1350: HMV 16.99.09.3023
BE1370: HMV 16.99.09.3022
European office
Asia Pacific office
Bellman & Symfon Europe AB
Bellman & Symfon Asia Ltd.
Södra Långebergsgatan 30
1115-16, Main Tower, GD Int'l Bldg
436 32 Askim
339 Huanshi Dong Rd
Sweden
Guangzhou, China, 510095
Phone +46 31 68 28 20
Phone +86 20 8318 2950
Fax +46 31 68 28 90
Fax +86 20 8333 5528
E-mail info@bellman.com
E-mail info.cn@bellman.com
© 2018, Bellman & Symfon AB, all rights reserved. Bellman, Bellman & Symfon and
the Bellman & Symfon logo are registered trademarks of Bellman & Symfon AB.
Publicité
