Gazebo Penguin 7170047 Manuel D'instructions page 6

STEPS
1. CENTER ARCHES
a) Take one center arch (F) and assemble at each end an extension (E). Note that extension (E) has a hole
at 6" from one end, this endgoes into the corner arch, not the center arch.
b) At each end of (E), install one corner arch 1 hole (H). Then attach the cross bar (D) with 2 screws 2½"
and wing nuts.
2. REPEAT STEP 1 FOR THE REMAINING REGULAR ARCHES.
3. ASSEMBLY OF END ARCHES
a) Take one center arch (F) and assemble at each end an extension (E). Note that extension (E) has a hole
at 6" from one end, this end goes into the corner arch, not the center arch.
b) At each end of extension (E), install one end corner arch (G) with 2 holes.
c) Take the completed arch and put screw 2½" (97-486) ) through holes on each side. Attach crossbar (D)
to screws and secure with wing nuts (90-019).
d) Take one door rail junction (B) and attach a door rail (A) at each end. Put one screw 1¾" (97-483) at each
end of (B) to secure (A) and tighten with wing nut (90-019).
e) Slide the shower hooks (90-015) over the door rail (A) and then install the rail to the corner arches, using
a screw 2½" (97-486) and wing nut at each end.
f) Take one door rail holder (C) and put one screw 1¾" to attach with junction (B). Put a 4" screw in
the other hole on (C) to attach with center arch (F). Secure with a wing nut.
g) Repeat step 3 with the remaining end arch.
h) Place one of the end arches at the front of the car shelter and the other at the back.
93-178
93-179
93-175
93-178
93-185
93-178
93-180
98-188
93-175
93-178
93-185
95-263
93-481
98-188