essentiel b CELESTIN Notice D'utilisation page 23

Dry suction
1. Remove the appliance from its base.
2. If necessary, select an attachment (see previous section) and insert
it at the end of the water and dust container.
3. To start the vacuum cleaner, move the "on/off" switch into the "I"
position (Fig. 5).
4. After use, turn the "on/off" switch into the "0" position then put it
back on its base to charge the battery for the next use (Fig. 5).
Suction of liquids
1. Perform steps 1 to 3 in the previous section on "Dry vacuuming".
2. Hold the container downwards at an angle of 30° to the ground. Never hold the container
upright when vacuuming liquids. Do not shake the appliance when liquids are already in
the tank to avoid any risk of leakage. Do not allow liquids to enter the motor unit.
3. After use, turn the "on/off" switch into the "0" position then put it back on its base to
charge the battery for the next use (Fig. 5 of the previous section).
!
Important!
• If you happen to hoover up some wet and/or perishable waste, make sure to
empty, clean and dry the dust container after use to avoid any risk of mould.
• Be careful not to fill the vacuum container beyond the MAX mark (shown
on the container) for dust or MAX
cleaningandmaintenance
!
Important!
• Always unplug the appliance before cleaning and check that the on/off switch
is in the "0" position.
• Never immerse the appliance, the charging base or the mains adapter in water
or any other liquid.
• Do not use aggressive cleaning agents or abrasive sponges.
All manuals and user guides at all-guides.com
for liquids.
cleaningandmaintenance
On
Off
Figure 5
23
V.1.0