Black & Decker FSL12 H2 Mode D'emploi page 4

All manuals and user guides at all-guides.com
ENGLISH
Chargers
Use your Black & Decker charger only to charge the battery
in the appliance with which it was supplied. Other batteries
could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
This appliance is intended for indoor use only.
Read all of this instruction manual carefully.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
will resume operating.
+40ºC
+10ºC Charge only at ambient temperatures between
10°C and 40°C.
Charging process completed.
Charging.
Features
This appliance has the following features:
1. On/off switch
2. Carrying strap
3. Battery
Fig. A, C and D
4. Battery release button
5. Charger
6. Charger receptacle
7. Charger connector
8. Charger plug
Assembly
Warning! Before assembly, remove the battery from the
appliance.
Fitting and removing the battery (fig. A)
To fit the battery (3), line it up with the receptacle on the
appliance. Slide the battery into the receptacle and push
until the battery snaps into place.
To remove the battery, push the release button (4) while
at the same time pulling the battery out of the
receptacle.
4
Fitting the battery cap (fig. B)
Warning! Fit the cap (9) to the battery (3) for transportation
and storage.
Charging the battery
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that
were easily done before. When charging the battery for the
first time, or after prolonged storage, it will only accept an
80% charge. After several charge and discharge cycles, the
battery will attain full capacity. The battery may become
warm while charging; this is normal and does not indicate a
problem.
Warning! Do not charge the battery at ambient
temperatures below 10°C or above 40°C. Recommended
charging temperature: approx. 24 °C.
Charging with the charger receptacle (fig. C)
To charge the battery (3), remove it from the appliance
and slide the charger receptacle (6) onto the battery.
Plug in the charger (5).
After normal use, a charging time of 3 hours will provide
sufficient power for most applications. However, further
charging for up to 6 hours could significantly increase the
use time, depending on the battery and charging conditions.
Remove the charger receptacle (6) from the battery (3).
Charging with the charger plug (fig. D)
To charge the battery, make sure that it is fitted on the
appliance.
Insert the charger plug (8) into the charger
connector (7).
Plug in the charger (5).
Switch the charger on at the mains supply.
After normal use, a charging time of 3 hours will provide
sufficient power for most applications. However, further
charging for up to 6 hours could significantly increase the
use time, depending on the battery and charging conditions.
Disconnect the charger connector (8) from the
appliance.
Warning! Do not use the appliance while it is connected to
the charger.
Replacing the bulb (fig. E)
The bulb can be replaced easily.
Warning! Do not touch the bulb shortly after using the
flashlight, as the bulb may be hot.
Remove the battery (3).
Remove the bulb holder (10) by turning it counter
clockwise.
Remove the bulb (11) by turning it slightly and pulling it
out of the bulb holder (10).