Winplus TypeS BT56883 Mode D'emploi page 29

Q: How long will it take the camera to charge?
A: No need to charge between usage for 7-way round plug mount and license plate mount as
the camera is powered by rear-light power source. If using magnetic mount option, it needs
approximately 5 hours to fully charge.
Q: Can the camera be left on constant power source so it's always charged?
A: Yes, if you hardwire to a constant 12V/24V power source the image will always be on. Be advised
that if the camera is always on, it will continue to draw power from the vehicle.
Q: How can I tell if the camera is on when pushing the power button?
A: You could tilt up the camera vertically and check the LED underneath. LED will be off after fully
charge.
Below is the LED signal table.
LED
BLUE
RED
RED (blinking)
RED with BLUE (blinking)
RED and BLUE
RED
22
All manuals and user guides at all-guides.com
STATUS
Camera is connected
Camera is not connected
The battery is low
Charging while not connected
Charging while connected
Charging when power is off