Publicité
Les langues disponibles
Les langues disponibles
Install Landing Pads.
• Using the hex wrench install each Catch Mount and pad as pictured (Catch Mounts are located diagonally from one another). Fully tighten.
• Using the hex wrench install the fastener, washer, Bare Mount, and pad as pictured (bare Mounts are located diagonally from one another).
To prevent screws from cross-threading start threading fastener using your fingers. Fully tighten.
CATCH MOUNT
RECOMMEND
INSTALLATION
TORqUE: 20 IN-LBS
(2.3Nm)
2X
ATTACHMENT
HARDWARE CAN
LOOSEN OVER TIME.
CHECK AND TIGHTEN
AS NECESSARY,
BEFORE EACH USE.
1035589B-3/9
FAsTeNer (M8)
FAsTeNer (M6)
• Use covers whenever skyLine or Control Towers are not installed.
• store covers in safe place whenever skyLine or Control Towers are installed.
• Periodically remove landing pad and clean under pad.
• Periodically inspect pad for wear or cracking. replace if damaged.
Continue with SkyLine or Control Tower installation.
BARE MOUNT
RECOMMEND
INSTALLATION
TORqUE: 20 IN-LBS
(2.3Nm)
2X
Publicité
