Yakima LANDING PAD 15 Mode D'emploi page 2

Remove factory crossbars.
Prepare Catch Mount.
1035589B-2/9
• Driver Side Rear & Passenger Side Front: Lift tab to release
crossbar. reference your owner's manual for more information.
• Passenger Side Rear & Driver Side Front: Use six lobe wrench
to remove factory installed fasteners.
• store fasteners and factory crossbars in a safe place.
DO NOT DRIVE VEHICLE WITHOUT EITHER FACTORY
CROSSBARS OR YAKIMA LANDING PADS INSTALLED.
• Using the hex wrench fully open both Catch
Mounts by turning the screw counter-clockwise.