Uline H-4406 Instructions D'installation page 4

7. Attach foot planks. Beginning with the bottom row,
place one foot plank on top of the clips, making
sure the clips rest under the plank in the outside
channels. The foot plank should have an 18"
overhang on both ends, measuring from the center
of the frame. Repeat for second foot plank.
(See Figure 13)
8. Confirm the frame is straight and square. Center of
the left foot plank frame to center of the right foot
plank frame should measure 6' on center.
(See Figure 14)
9. Underneath the foot plank, turn the clips vertical so
the grooves of the clip fit securely under
the channel lips. Tighten the
clips with flange nuts.
(See Figures 15-17)
Figure 15
PAGE 4 OF 12
ASSEMBLY CONTINUED
Figure 13
18"
6'
Figure 14
Figure 16
Figure 17
Flange
Nut
10. Attach the seat planks. Starting from the top row,
place one seat plank on top of the clips, making
sure the clips are resting under the plank in the
outside channels. (See Figure 18)
Figure 18
Seat Plank
11. The seat planks should have an 18" overhang on
both ends, measuring from the center of the frame.
Make sure the seat end is square with the foot
planks (should line up corner to side). Repeat for the
remaining seat planks. (See Figure 19)
12. Tighten all clip connections with socket wrench.
1-800-295-5510
uline.com
5/16" Carriage Bolt
Hold Down Clip
Frame
Foot Plank
Figure 19
0822 IH-4406