Airworks FFH2 Mode D'emploi page 4

15. To prevent overload and blown fuses, be sure that no other appliance is plugged
into the same outlet (receptacle) or into another outlet (receptacle) wired into
the same circuit.
16. It is normal for the heater's plug and cord to feel warm to the touch. A plug or
cord which becomes hot to the touch or becomes distorted in shape may be a
result of a worn electrical outlet. Worn outlets or receptacles should be
replaced prior to further use of the heater. Plugging heater into a worn
outlet/receptacle may result in overheating of the power cord or fire.
17. Ensure the heater is on a stable, secure surface to eliminate the potential of
tipping it over.
18. We do not recommend use of an extension cord as it may overheat and cause a
risk of fire. However, if you have to use an extension cord, the cord should be
No. 14 AWG minimum size and rated not less than 1875 watts, and has to be
used only for supplying power to this heater.
19. Be sure that the plug is fully inserted into appropriate receptacle. Please
remember that receptacles also deteriorate due to aging and continuous use:
check periodically for signs of overheating or deformations evidenced by the
plug. Do not use the receptacle and CALL your electrician.
20. Check that neither the appliance nor the power cable has been damaged in any
way during transportation.
21. Make sure that no pieces of polystyrene or other packaging material have been
left between elements of the appliance. It may be necessary to pass over the
appliance with a vacuum cleaner.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
FFH2 Airworks Fan Forced
4