Yamaha YID-W10 Mode D'emploi
Yamaha YID-W10 Mode D'emploi

Yamaha YID-W10 Mode D'emploi

Yaired; système sans fil pour ipod
Masquer les pouces Voir aussi pour YID-W10:

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

YID-W10
Wireless System for iPod
Système sans fil pour iPod
OWNER'S MANUAL
MODE D'EMPLOI
UC
English
Français

Publicité

Table des Matières
loading

Sommaire des Matières pour Yamaha YID-W10

  • Page 1 English YID-W10 Français Wireless System for iPod Système sans fil pour iPod OWNER’S MANUAL MODE D’EMPLOI...
  • Page 3: Fcc Warning

    The above statements apply ONLY to those products operation of other electronic devices. distributed by Yamaha Corporation of America or its subsidiaries. This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.
  • Page 4: Important

    – and, most importantly, without affecting your sensitive hearing. Since hearing damage from loud sounds is often undetectable until it is too late, Yamaha and the Electronic Industries Association’s Consumer Electronics Group recommend you to avoid prolonged exposure from...
  • Page 5 Introduction 1: Connection 1 Turn off your Yamaha component and YID-W10 is a wireless system designed for iPod/ iPhone series. YID-W10 employs the Yamaha then disconnect its power cable from the “yAired” technology to establish a wireless AC outlet. connection with another Yamaha dock-compatible 2 Connect the dock cable to the Yamaha component (hereinafter referred to as “Yamaha...
  • Page 6 Flashes green once Adjusting the volume level. Flashes green continuously Connection in progress, please wait. Flashes red once The volume of Yamaha component is set to maximum or minimum. Flashes red for 2 seconds An unsupported iPod is connected. Flashes red continuously Error occurs.
  • Page 7: Battery Charge

    If the unit does not function properly, first of all, check the firmware of your iPod/iPhone is the latest version. If it is the latest version, refer to the table below. If the problem you are experiencing is not listed below, or if the instruction below does not help, contact the nearest authorized Yamaha dealer or service center. Transmitter...
  • Page 8 Transmitter Problem Cause Remedy Green: flashes The sound is There is a device Move YID-W10 away from interrupted. (microwave oven, cordless the device. Red: Off phone, Wi-Fi, etc.) outputting signals in 2.4 GHz frequency band nearby. The signal from the...
  • Page 9 Yamaha component Yamaha component. referring to its owner’s manual. The Wi-Fi The signal from YID-W10 Disconnect your iPod/ communication interferes with Wi-Fi iPhone from the transmitter, is unstable when communication. and then reconnect firmly you are using after a while.
  • Page 10 Supported iPhone (as of April 2010) The “ ” and “yAired” are ......iPhone, iPhone 3G, iPhone 3GS trademarks of Yamaha Corporation. Frequency ........... 2.4 GHz Transmission Range ....Approx. 20m (66 ft) (without interference) iPhone, iPod, iPod classic, iPod nano and Number of units which can be simultaneously iPod touch are trademarks of Apple Inc.,...
  • Page 11: Avertissement De La Fcc

    Si ce n’est pas possible, prière de contacter Yamaha Electronics Corp., États-Unis, appareils électroniques dans une installation résidentielle. Cet équipement génère et utilise des fréquences radio qui, en 6660 Orangethorpe Ave., Buena Park, CA 90620.
  • Page 12: Nous Vous Souhaitons Un Plaisir Musical Durable

    Comme les sons trop forts causent des lésions auditives qui ne peuvent être détectées qu’à long terme, lorsqu’il est trop tard, Yamaha et le Groupe des Entreprises Électroniques Grand Public de l’Association des Industries Électroniques vous déconseillent...
  • Page 13: Raccordement

    Introduction 1: Raccordement 1 Mettez votre dispositif Yamaha hors Le YID-W10 est un système sans fil pour les appareils des gammes iPod/iPhone. Grâce à la tension et débranchez son cordon technologie Yamaha “yAired”, le système YID-W10 d’alimentation de la prise de courant.
  • Page 14 Clignote en vert sans interruption Connexion en cours, veuillez attendre. Clignote une fois en rouge Le volume du dispositif Yamaha est réglé au niveau maximum ou minimum. Clignote en rouge pendant 2 secondes L’iPod connecté n’est pas pris en charge.
  • Page 15: Charge De La Batterie

    (“firmware”) de votre iPod/iPhone affiche la dernière version disponible. Si la dernière version est installée, voyez le tableau ci-dessous. Si le problème rencontré n’est pas repris dans cette liste ou si les instructions ne suffisent pas à régler le problème, veuillez contacter le revendeur ou le service après-vente agréés Yamaha le plus proche.
  • Page 16 Problème Cause Solution l’émetteur Verte: clignote Le son comporte Un appareil (four micro- Éloignez le YID-W10 de cet des coupures. ondes, téléphone sans fil, appareil. Rouge: éteinte dispositif WiFi, etc.) émet des signaux de bande de fréquence de 2,4 GHz à...
  • Page 17 Yamaha votre dispositif Yamaha. en vous reportant à son mode d’emploi. Le signal du YID-W10 Débranchez votre iPod/ communication cause des interférences avec iPhone de l’émetteur et Wi-Fi est la communication WiFi.
  • Page 18: Caractéristiques Techniques

    (en avril 2010) Le logo “ ” et “yAired” sont des ......iPhone, iPhone 3G, iPhone 3GS marques commerciales de Yamaha Fréquence ........... 2,4 GHz Corporation. Portée d’émission ..Environ 20m (sans brouillage) Nombre d’appareils auxquels le signal peut être simultanément transmis (YIT-W11TX)
  • Page 20 © 2010 Yamaha Corporation Printed in China WV30490-2...

Table des Matières