Thermostat Installation; Wiring - Emerson 1F83C-11PR Instructions D'installation Et D'utilisation

WIRING

Refer to equipment manufacturer's instructions for specific system wiring information. After
wiring, see INSTALLER MENU for proper thermostat configuration. Wiring table shown are
for typical systems and describe the thermostat terminal functions.
Terminal Designations
*When both RC and RH wires are present, cut RC/RH jumper (see next page).
**For heat pump systems, add a jumper wire to connect terminals Y and W
Precautions
• Do not exceed the specification ratings.
• All wiring must conform to local and national electrical codes and ordinances.
• This control is a precision instrument, and should be handled carefully. Rough handing or
distorting components could cause the control to malfunction.
!
Do not use on circuits exceeding specified voltage.
Higher voltage will damage control and could
cause shock or fire hazard.
Do not short out terminals on gas valve or primary
control to test. Short or incorrect wiring will burn
out thermostat and could cause personal injury
and/or property damage.
2

THERMOSTAT INSTALLATION

RC*
RH*
O/B
Y**
G
W**
C
WARNING
Terminal Function
Power for Cooling
Power for Heating
Changeover Terminal-Energized in Heat (B) or Cool (O)
for Heat Pump or Damper Systems
Cooling Relay
Fan Relay
Heating Relay
Common wire for 24V (optional with batteries)
!
To prevent electrical shock and/or equipment
damage, disconnect electrical power to system,
at main fuse or circuit breaker box,until
installation is complete.
Leveling Thermostat
Leveling is for appearance only and
will not affect thermostat operation.
CAUTION