Publicité
5
Place the H Middle Shelf (Thin) at the center of
the Side Panels. The front edge of the Shelf has a
thick flange, and the back has a center hole. Align
the holes in the Shelf corners with the holes in the
Back Panel, and fasten with G Sheet Metal
Screws, one at each of four corners.
Hint: You may find it
easier to turn the unit
on its side to install
these screws.
7
Steps 7 - 10 may be easier with the unit on its back.
In one of the open compartments, place a I Plastic
Inner Side Panel against an Outer Side Panel, with
the FRONT side (with the grooves) facing the
INSIDE of the unit. Insert the BACK edge first,
tucking it into the back corner, then carefully but
firmly press the front edge into the Outer Side Panel.
Repeat on the other side of the compartment, and in
the remaining compartment.
7121-37: 3 of 4; Rev. 7; 07/02
All manuals and user guides at all-guides.com
H
G
I
Safco Products Company, New Hope, MN 55428
6
Set the unit upright and, from the back side, insert
a E Plastic Push Fastener into the BOTTOM
center hole of the Back Panel, and tap as before.
Insert a Fastener into the center hole for the Middle
Shelf, and tap into place.
8
Carefully fold one of the J Corrugated Shelves in
half along the creases. Insert it (with the creased
edge forward) into the bottom pair of slots in the
Inner Side Panels (bend the Shelf slightly to get the
ends into the grooves).
Continue inserting Corrugated Shelves into each of
the remaining sets of grooves.
GROOVES
E
J
Publicité
