Blaupunkt BP-GIKLED09 Mode D'emploi page 5

BP-GIKLED09
5. Operation
5.1. Introduction
5.2. How to Use
5.3. Sticky Pads
P-GIKLED09.indd 5
This insect killer uses an LED to attract flying insects. The fan will suck these insects
into the container and dry them. This insect killer does not produce any noisy
electric shocks nor does it emit any toxins, smoke, scent or radiation.
This insect killer is designed to be used indoors (bedroom, living room).
Keep the insect killer working for more than 12 hours at first use. Do not open the
container during use. Make sure the insects are dried to death to prevent them from
escaping.
Keep the insect killer working for 3 hours before going to sleep. Make sure to keep
windows and doors closed.
1. Connect the insect killer to a 5 V power supply. Install the insect killer in a dry
location on a stable and non-slippery surface.
Select the silent or strong mode. Press the button to start the insect killer.
2.
3. Press the same button to stop the insect killer. Disconnect from the power
supply after use.
For best results, turn off other light sources and prevent from installing the
appliance in the draught.
1. Switch of the appliance and disconnect from the mains.
2. Remove the protective layer of the sticky pad.
3. Apply it at the bottom of the storage tray. Replace when covered with bugs.
4. Close the tray and reconnect the appliance to the mains.
5
12/01/2021 15:48:29