Publicité
Les langues disponibles
Les langues disponibles
Reference
Maintaining the system
Changing the remote control battery is the only regular maintenance that is required. You may also clean the
system as needed.
To replace the remote control battery
Replace the remote control battery when it stops operating (normally every year or two), or its range seems
reduced. Use only a Duracell, Eveready, Energizer, Maxell, Toshiba, or Shun Wo CR2032 3-volt lithium battery.
Keep in mind that lighting and other room conditions, in addition to battery age, can affect the operating range
of an infrared remote control.
To clean the system
Wipe the system using a soft dry cloth. You can also lightly vacuum the grille.
• Do not use solvents, chemicals, or sprays.
• Do not allow liquids to spill or objects to drop into any openings.
Specifications
Input Requirement
Main Connection iPod docking connector
Auxiliary connection - 1 / 8" (3.5mm) mini stereo jack
Power Rating
Total 10 Watts RMS
Satellite speakers
2 x 2.5 Watts (4 ohm)
30mm drivers
Subwoofer
1 x 5 Watts (8 ohm)
2.5" dedicated low frequency high excursion driver
Power Supply
External AC Adapter (100 - 240V)
Frequency response
60Hz - 20KHz
Dimensions
6.1" x 6.9" x 5.7" (width x height x depth)
155mm x 176mm x 145mm (width x height x depth)
Weight
28.9oz / 820g
www.astone.com.au
10
All manuals and user guides at all-guides.com
Reference
Troubleshooting
Problem
What to do
Your iPod does not dock
•
Check whether there is any barrier in the iPod jack or not.
properly
•
Check whether the direction of iPod jack pins are all the same or not.
No sound
•
Make sure the system is plugged in, your iPod is turned on, and a music track is
selected and playing.
•
Press the PLAY / PAUSE button on the remote control.
•
Increase the volume setting for the system.
•
Remove your iPod from the dock, wait briefly, then reseat it. You may need to do
this a few times.
No sound and your iPod
•
Make sure the power cable is securely plugged into a functioning outlet and with
is not charging
the DC plug plugged firmly into the DC input jack.
•
Make sure your iPod is firmly seated in the dock.
Your iPod does not respond
•
Remove your iPod from the dock, wait briefly, then reseat it. You may need to do
to the i-Ballroom remote
this a few times.
control buttons shown
•
Try the remote from a different location. If it works there, strong lighting or other
room conditions may be causing the problem.
•
Make sure nothing blocks the infrared (IR) signal path from the remote to your
i-Ballroom system. wipe off the small red lens on the front send of the remote.
•
Check the remote control battery to make sure the + side is up.
•
Replace the remote control battery.
No sound, or cacophony
•
Check the antenna to make sure it has already been plugged into the matched
when using the FM function
jack.
•
Check the system to make sure the FM function has been turned on.
Low sound
•
Check the system to see whether the volume is adjusted to the smallest status or
not.
•
Check the audio source to see whether the output is too small or not.
Your i-Ballroom system does
•
Unplug the power cable for 1 minute, then plug it back in. This resets the system.
not respond to its remote
•
Contact ASTONE Customer Service about the problem.
commands or to the + and
volume buttons on the front
of the system
www.astone.com.au
11
Publicité
