Textron Greenlee ULTRA GLIDER UG5 Manuel D'instructions page 6

Setup (cont'd)
Selecting and Attaching Applicators
Applicators are available in two styles—threaded and
slip-in.
• Threaded applicators can be used on any conduit that
has threaded ends. They are available in conduit sizes
from 3/4" to 4".
• Slip-in applicators can be used on any conduit where
the feed direction is horizontal or downward and
where a slight reduction of the conduit fill area is
permissible. They are available in conduit sizes from
1-1/2" to 6". Slip-in applicators are stepped to fit both
schedule 40 and 80 conduit.
To attach an applicator:
1. Select the appropriate applicator for the application.
2. Remove one of the pins and open the applicator.
Note: If feeding upward into EMT conduit, fit a
threaded EMT adapter (if one is not already fitted)
onto the conduit, and attach a threaded applicator
to the adapter.
Greenlee / A Textron Company
All manuals and user guides at all-guides.com
3. For threaded applicators, attach the applicator to
4. Attach the hose to the quick connect nipple on the
6
UG5 Cable Lubrication System
the threads of the conduit so that the quick connect
nipple is accessible. Close the applicator and re-
insert the pin. Screw the conduit bushing onto the
male threads of the applicator.
Quick
Connect
For slip-in applicators, place the applicator around
the pull rope. Close the applicator and re-insert the
pin. Fully insert the applicator into the conduit.
Quick
Connect
applicator.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070