human care 4200 Serie Manuel De Fonctionnement page 3

OPERATING MANUAL – ENGLISH
ASSEMBLY
Remove the height adjustment
screws from handles.
1
To install/remove backrest on WX and SWX models, pull up on the backrest
knob (1) and insert the backrest into the backrest connector located on the
frame. Once inserted, release the backrest knob to hold into position.
FEATHER TOUCH HAND BRAKING SYSTEM
1
2
USING YOUR WALKER
TO SIT, touch the back of your legs to the edge of the seat to ensure position of
walker before sitting down.
This walker is designed for use as a walking aid and should never
be used for any other purpose.
All manuals and user guides at all-guides.com
Slide handles into frame and insert
height adjustment screws to desired
height.
1
3
4
IMPORTANT:
Test to be sure walker
will not roll before attempting to sit.
Brakes must be in parked/locked
position.
Place screw head through the
adjustment hole from the inside of
the walker frame (be sure the hex
screw fits into cut out in the frame.)
Ensure that all bolts are securely fastened before
using the walker!
Brakes must be in the parked/locked position before
sitting on the walker!
1. Locking Nut
2. Tension Adjustment Screw
3. Housing
4. Handle
5. Brake Handle Arthritic Ball
5
When receiving your new walker, the brake system will be preset from the factory. To
maintain this preset position, be sure that the Locking Nut is tight against the Housing.
This is the same for the Tension Adjustment Screw Locking Nut located at the rear wheel.
(To adjust see: Brake Usage/Adjustment)
DO NOT support your weight on the handles when attempting to sit. Use the
handles to stabilize your body as you carefully turn around. Keep your handles
on the foam handles and slowly lower your weight onto the seat.
Ensure when walking your path is clear and free of obstacles to
avoid injury and damage.
From the outside of the frame tighten
the black adjustment knob onto the
screw.
To install basket, simply hook onto
frame.