Inglis IP43000 Guide D'utilisation Et D'entretien page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. (OPTIONAL STEP) Pour measured liquid chlorine
bleach into the liquid chlorine bleach dispenser (on
some models). Bleach will be diluted automatically
during the wash part of the cycle.
Never use more than 1 cup (250 mL) for a full load.
Use less with a smaller load size.
Follow the manufacturer's directions for safe use.
To avoid spilling, use a cup with a pouring spout. Do
not let bleach splash, drip, or run down into the
washer basket.
Use only liquid chlorine bleach in this dispenser.
4. (OPTIONAL STEP) Pour measured liquid fabric
softener into the liquid fabric softener dispenser (on
some models). Softener is added automatically during
the rinse portion of the cycle.
Dilute liquid fabric softener by filling the dispenser
with warm water until liquid reaches the crossbar in
the opening.
Do not spill or drip any fabric softener on the
clothes.
Use only liquid fabric softener in this dispenser.
5. Close the washer lid.
6. Turn the LOAD SIZE selector to the correct setting for
your wash load and the type of fabric being washed.
Choose a load size that allows the load to move
freely for best fabric care. See "Loading".
You may change the load size selection after the
washer has started filling by turning the selector to a
different setting.
7. If your model has a separate TEMPERATURE selector,
set it to the setting for the type of fabric and soils being
washed.
NOTE: On models without a separate Temperature
selector, see "Cycle Options" in the "Selecting a Cycle
and Time" section.
Use the warmest water safe for fabric.
Follow garment label instructions.
HOT: 111°F (44°C) or above
– Whites and pastels
– Heavy and greasy soils
WARM: 90° to 110°F (32° to 43°C)
– Bright colors
– Moderate to light soils
COLD: 70° to 90°F (21° to 32°C)
– Colors that bleed or fade
– Light soils
8. Push in the Cycle Control knob and turn it clockwise to
the wash cycle you want. Reduce the wash time when
using a small load size setting.
9. Pull out the Cycle Control knob to start the washer.
7

Publicité

Table des Matières
loading

Table des Matières