Publicité
Les langues disponibles
Les langues disponibles
1. Always disconnect the cord from the electrical outlet when cleaning your fan.
2. Light accumulated dust may be removed by using a soft cloth to wipe away the dust at the back grille of the fan.
3. Wipe the exterior surfaces of the fan occasionally with a damp cloth (not dripping wet) and dry thoroughly with a soft
dry cloth before operating the fan.
4. Do not use harsh cleaners or materials to clean this unit, doing so will cause damages to it.
CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE FAN AS THIS COULD CREATE A FIRE
OR ELECTRIC SHOCK HAZARD. THE FAN MOTOR IS FACTORY LUBRICATED FOR LIFE AND WILL REQUIRE NO
FURTHER LUBRICATION. NO OTHER USER MAINTENANCE IS REQUIRED OR RECOMMENDED. IF SERVICE IS
REQUIRED, SEND YOUR FAN TO THE NEAREST SUPER ELECTRIC AUTHORIZED SERVICE DEPOT.
1. Follow cleaning instructions 1-4 above. Make sure to disassemble and clean fan before storing.
2. Retain the original packaging to store your fan.
3. Always store in a dry place.
4. Never store while still plugged in.
5. Never wrap cord tightly around the fan or put any stress on the cord where it enters the fan as it could cause the cord
to fray or break.
If your fan fails to operate, please follow these procedures prior to contacting customer service:
PROBLEM
PROBABLE CAUSE
Fan is not plugged into a
120V AC, 60Hz
polarized
outlet/receptacle.
Fan is not turning
on.
Breaker/fuse has been
tripped.
Oscillation
The oscillation knob has
function is not
not been activated.
working.
Fan is on but air
coming out of it is
There is dust built up at
not strong
the back of the fan.
enough.
If the problem still persists, refer to the warranty. For further instructions, call 1-800-268-7622 or visit
www.super-electric.com
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE FAN YOURSELF. DOING SO COULD
VOID THE WARRANTY AND CAUSE DAMAGE OR PERSONAL INJURY.
AIRWORKS
29TFOM
All manuals and user guides at all-guides.com
CLEANING & MAINTENANCE
TROUBLESHOOTING
with the model number of this fan ready for the service center.
STORAGE
SOLUTION
Ensure unit is in the OFF position. Plug in unit and
attempt to turn on again.
Please check your electrical box to confirm the breaker
has not been tripped. Ensure unit is in OFF position.
Plug in unit and attempt to turn on again.
Attempt to plug unit in another receptacle in the house.
Simply press the oscillation knob down to start the
oscillation function. This can be done while the fan is
operating.
Turn fan OFF and unplug. Using a soft, dry cloth, wipe
the back of the grille to remove any dust build-up. Plug
in unit and turn fan back ON to resume normal
operation.
5
Publicité
