Publicité
Les langues disponibles
Les langues disponibles
Follow these steps to start assembling fan:
1. Turn the fan upside down.
2. Following Figure 1, remove the three screws with a screw driver and reserve for later.
3. Find fan base Piece B (Bottom of Figure 2). Position the power cord through the escape route (Figure
2). Fit fan base Piece B onto the bottom of the fan (Figure 1) by aligning the slots and pegs.
4. Find fan base Piece A (Top of Figure 2) and fit onto the pegs of fan base Piece B.
5. Secure the base pieces to the bottom of the fan by restoring and tightening with a screwdriver, the 3
screws which were removed from step 1.
6. Turn fan right-side up. It is now ready to operate.
Ensure the fan is in the OFF position before plugging into a 120V/60Hz outlet.
This fan has a 5 push button control panel with a timer control dial:
[ 0 ]
Pressing this button will power the fan OFF.
[ 1 ]
Pressing this button will power the fan ON at LOW speed setting.
[ 2 ]
Pressing this button will power the fan ON at MODERATE speed setting.
[ 3 ]
Pressing this button will power the fan ON at HIGH speed setting.
OSCILLATION:
To activate the oscillation function for widespread breeze distribution, simply press this button
found on top of the fan's control panel. To turn off the oscillation function for a targeted breeze
setting, push this button once more. Controlling the oscillation can be done while the fan is
operating.
TIMER:
This fan is equipped with a timer, which can be set up to a maximum of 120 minutes. The timer counts down
from the set time and will automatically turn off. Do not use this function if it is desired to keep the fan operating
indefinitely.
CAUTION: TO PREVENT ELECTRICAL SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
AIRWORKS
29TFOM
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
SPECIFICATIONS
MODEL
VOLTAGE (V)
WATTAGE (W)
29TFOM
120V AC, 60Hz
35W
4
Publicité
