Formidra CUVA Guide D'installation & D'utilisation page 6

InstallatIon GUIDE anD UsER's ManUal
CAuTION
During the hottest days of summer, it is possible that the temperature of the water contained in the tank exceeds
60°C. Before taking a shower, mix the water, put the mixer on «cold water» and then adjust the temperature
progressively until obtaining a pleasant temperature.
Do not touch the surface of the shower in order to avoid any risk of superficial burns.
It is possible that water continues to run after turning off the shower. This is normal and it stops within the fol-
lowing 10 – 15 seconds.
Do not use the shower in case of storms, in order to avoid any risks of lightning.
The solar shower is designed to be used under "normal" water supply conditions, with a pressure lower than 3
bars (3 kg). Otherwise install a water pressure reducer.
INSTALLATION
1. Choose a location well exposed to direct sunlight (ideally to 360°) near a water supply and drainage.
2. On a solid support (cement, reinforced concrete, heavy wooden base) drill 4 holes approximately of 12mm of
diameter and of 90 mm of depth, using the base of the shower as a reference. (fig. a)
3. Put the anchors and install the solar shower vertically with the help of washers and screws. (fig. b)
4. Install the shower head fastening it on the shower body. (fig. c)
5. Install the handheld shower and tube on the shower body. (fig. d)
6. Assemble the 15/21 threaded tap connectors then fastened them on water inlets. Connect to the water sup-
ply. If necessary use an adapter. (fig. e)
296
324
fig. a
fig. b
6
fig. c
fig. e
Hot water
Cold water
fig. d