Uline H-8520 Mode D'emploi

H-8520
4-DRAWER
TOOL CART
TOOLS NEEDED
5 mm Hex Wrench
Chest x 1
Bottom Tray x 1
CAUTION! Only open one drawer at a time to
keep cart from tipping over.
• Close chest lid and lock drawers before moving.
• Do not stand on the cart or climb on drawers. Doing
so may result in injury.
• Do not place the cart on truck bed or any other
moving object.
Figure 1
PAGE 1 OF 9
All manuals and user guides at all-guidesbox.com
1-800-295-5510
uline.com
13 mm Wrench
Handle x 1 Swivel
Caster x 2
Long Strut x 2
PARTS
Rigid 5/16 x 1/2" 5/16 x 5/8"
Caster x 2 Bolt x 38 Bolt x 2
Short Strut x 2
Leg x 4
SAFETY
• Lock swivel casters to keep cart stationary.
• Do not pull. Push to move.
• Lubricate the top and bottom channels of the
drawer slides at least twice a year.
ASSEMBLY
ATTACH CASTERS
1. Place bottom tray on side. (See Figure 1)
2. Align caster with holes on bottom tray.
3. Attach caster to the bottom of tray with four M8 hex
head bolts and four M8 nuts. Ensure the bolt heads
are inside the tray. Use hex wrench to tighten, but
don't fully secure until all casters are attached.
4. Repeat Step 3 for the remaining casters.
NOTE: Install rigid casters on one end of bottom
tray and swivel casters with brakes on the
opposite end.
5. Completely tighten all bolts.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
M8 x 15 mm 13 mm M8 Nut
Hex Head Nut x 40 x 16
Bolt x 16
Cart Key x 2 Drawer Liner x 4
0521 IH-8520