Publicité
STEP 1
Remove existing drawer box from
cabinet by squeezing the drawer
locking devices and pulling the
drawer box forward.
Use a pencil to trace around the
bottom two corners of the drawer
and onto the back of the drawer
front (See Figure A).
Remove the screws that secure
the drawer front to the drawer
box (See Figure A). Discard the
existing drawer box.
Note: Not all existing drawer
boxes will have release triggers
like the ones shown in Figure A.
A EURO roller slide or various
other drawer slides may involve
alternate removal methods.
If your existing drawer box
is without triggers underneath
the box, there may be locking
devices located on the
slides elsewhere.
#2
#2
STEP 2
Install the right and left Blum
release triggers on the bottom of
the drawer using (4) #6 x 1/2" pan
head screws (See Figure B).
STEP 3
Install the figure 8 brackets onto
the front of the drawer using the
screws that come inside of the
same bag as the figure 8 brackets
(See Figure C-1).
Once the (2) Figure 8 brackets have
been secured to the drawer box
align the drawer box to the back of
the drawer front.
Align the bottom corners of the
drawer box with the pencil marks
from Step 1. Drill a 7/64" wide X
3/8" deep pilot hole through the
middle of each bracket and into the
back of the drawer front. Be careful
to not drill through the drawer
front. Secure the drawer box to the
drawer front with (2) Phillips head
screws (See Fig. C-2).
2
All manuals and user guides at all-guides.com
FIG. A
FIG. B
FIG. C-1
Customer Service: 800-626-1126 | rev-a-shelf.com
Bottom view
FIG. C-2
Publicité
