Uline H-1030 Manuel page 3

STAPLE LEG LENGTH
1. Loosen the set screw on the bottom with a 3 mm Allen
wrench. (See Figure 4)
Figure 4
2. Adjust L/S screw with a screwdriver to the desired
setting. (See Figure 5)
Figure 5
NOTE: If you are using 3/4" staples, set L up.
(See FIgure 6)
NOTE: If you are using 5/8" staples, set S up.
(See Figure 6)
Figure 6
3. Tighten set screw on the bottom.
PAGE 3 OF 24
OPERATION CONTINUED
CLINCH ADJUSTMENT
Use 2.5 mm Allen wrench and turn collar through window
clockwise to tighten clinch. (See Figure 7-9)
Figure 7
Tight
Medium
Loose
Figure 8
Loosen
Tighten
Figure 9
0323 IH-1030