Publicité
Les langues disponibles
Les langues disponibles
TO REPLACE CUTTERS
NOTE: Always replace the cutters and foil head assembly at the same time.
1. To remove cutters, place your fingers on each side and gently pull up and
away from drive shaft.
2. To replace cutters, remove the new cutters (FXRF1) from the packaging.
Align cutter about the drive shaft and lightly push down until it snaps into
place.
3. Replace the foil head assembly, turn shaver on to ensure it is working
properly.
GOOD
Daily Maintenance:
1. Press the release button on the side of shaver and remove the head
assembly (see Fig. 1 & 2).
2. Use cleaning brush to whisk away any debris on and around cutter (See
Fig. 3).
3. Snap the head assembly closed (see Fig. 4).
Fig. 1
Fig. 2
FXFS1 IB-15501.indd 7-8
All manuals and user guides at all-guides.com
BAD
Fig. 3
Fig. 4
Weekly Maintenance:
1. Repeat steps 1 – 3 from the Daily Maintenance cleaning steps.
2. Rinse the head of the shaver under running water (see Fig. 5). NEVER
submerge the shaver in water.
3. Leave head open for drying.
4. Press the shaver head back into place (see Fig. 4).
Fig. 5
Washable
BATTERY REMOVAL
1. Remove the metal housing by sliding the release button over and pulling the
bottom cover off.
2. Remove batteries by pulling them out and away from battery contacts.
3. Dispose used batteries.
Protective Cover
Internal Housing
AA Batteries
Bottom Cover
Release Button
3/21/18 11:55 AM
Publicité
