Télécharger Imprimer la page

BOMANN EKI 5026 CB Mode D'emploi page 45

Plaque de cuisson à induction

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
WARNING:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down completely!
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Glass ceramic Hob
• Clean the surface from food remains when it's still warm
using a moist cloth or tissue.
• Wash the hob using a soft sponge and some water, then
wipe dry with a soft cloth.
• Cleaning agent for glass-ceramics surfaces: In case of
stubborn, baked-in remains, use suitable cleaning products
available at special departments of department stores.
Housing
• Clean the housing after use using a slightly moist cloth.
• Make sure that no fluid matter gets into any of the openings
of the housing. This might damage the device or result in an
electric shock.
Storage
• Only store the appliance clean and after it has cooled down.
• During longer periods of non-use we recommend storing
the appliance in its original packaging.
• Always store the appliance in a well-ventilated and dry
place out of reach of children.
CAUTION: Risk of breakage!
Please note that the glass ceramic surface can be damaged
by heavy or falling objects.
Troubleshooting
• Device does not function, no indication on the display.
Remedy:
Check the mains connection.
• Several warnings will sound after the appliance has
been turned on and after the cooking function has
been selected.
Cleaning
Possible cause:
No cookware or unsuitable cookware was placed onto
the plate.
NOTE:
For safety reasons, the appliance will switch to standby
mode after about 30 seconds.
Remedy:
Put a pot on the hob that is suitable for induction hobs.
• The hob suddenly switches off during operation.
Possible cause:
The thermal cut-off is activated.
Remedy:
Disconnect the appliance from mains power supply and let
it cool down for approx. 20 minutes. Then start operating
the device again.
Further cause:
The ventilation slots are obstructed.
Remedy:
Free the ventilation slots from any obstructions.
Further cause:
The hot plate was automatically switched off after
120 minutes.
During operation the following error messages can be
displayed:
Message
E0
The cookware is unsuitable.
E01
Temperature sensor IGBT has failed.
E02
Overheating.
Problem with power supply. Check the
E03
power supply!
Error messages
45

Publicité

loading