Publicité
Les langues disponibles
Les langues disponibles
Support
Framing
2. Install the Support Frame
IMPORTANT! Horizontal and vertical support framing is required
to support the weight of the sink.
NOTICE: For proper countertop installation, the top of the sink
must not extend above the top of the cabinet.
Cut two lengths of support framing to extend horizontally along
the inside walls on each side of the cabinet.
Measure and mark the support mounting locations. Make sure
the sink rim will sit at or slightly below the top of the cabinet.
Position and level the supports.
Secure the supports with construction adhesive and screws (not
provided).
Cut four lengths of support framing to extend from the bottom of
the installed supports to the floor of the cabinet.
Secure the vertical supports with construction adhesive and
screws (not provided).
1400422-2-A
1/2"
(13 mm)
4
Kohler Co.
Publicité
