Publicité
Les langues disponibles
Les langues disponibles
EN
WIRELESS ELECTRONIC ROUTING
1 - Install the seatpost (see: Seatpost Assembly)
2 - For the cable routing, it is important to secure the
frame on a workstand by the seatpost, tightening to
a torque of 7Nm. This allows for easier access to the
headset and bottom bracket.
3 - Insert the rear brake hose into the left-hand
chainstay, then over the bottom bracket and up the
down tube. The hose should then exit through the
top of the head tube.
4 - Insert the front brake hose through the left fork
leg and exit through the top of the head tube.
5 - Slide a pre-prepared, 510mm foam tube onto the
rear brake hose.
6 - Cut your steerer tube if you wish to adapt the
bike to your fitting requirements (see Headset and
expander assembly).
7 - Finalize the routing by threading the hoses
through all the headset parts, stem and handlebars.
EN
Publicité
